Green Rubber-Kennedy AG
Green Rubber-Kennedy AG
1310 Dayton Street Salinas, CA 93901
Tel: 800.273.2464
Fax: 831.753.6111
Email: sales@greenrubber.com
Print Back
When using B Series Field Attachable Couplings on T2D Series Hose, cover of hose must be skived at ends. Refer to page 31 for Skive Length. Contact RYCO for Crimp Diameter and Mark Length for Bitelok Couplings.
Unit of Measure

Specifications

Hose Inner Diameter (DIN)

 N/A 50 mm

Hose Inner Diameter

 N/A 2 in

Dash Size

 N/A -32

Maximum Dynamic Working Pressure

 N/A 80 bar1150 psi

Maximum Static Working Pressure

 N/A 107 bar1530 psi

Minimum Burst Pressure

 N/A 320 bar4600 psi

Minimum Bend Radius

 N/A 600 mm24.0 in

Average Weight

 N/A 3.50 kg/m2.35 lb/ft

Nominal Hose Outer Diameter

 N/A 67.3 mm2.65 in

Field Attachable L (& B) Series Insert

 N/A 600 Series

Field Attachable L (& B) Series Ferrule

 N/A B00-32

Bitelok One Piece Crimp

 N/A T700
Temperature1 N/A -40 to 100 ºC-40 to 212 ºF

Reinforcement

 N/A Two braids of high tensile steel wire.

Tube Color

 N/A Black

Tube Material

 N/A Oil-Resistant Synthetic Rubber (Nitrile)

Cover Color

 N/A Black

Cover Material

 N/A Extra Abrasion and Oil resistant Rubber

Note for Cover

 N/A "FRAS" Flame Resistant and Anti-Static. The weight loss of the cover under ISO 6945 method of test for abrasion resistance is less than 10% (less than 0.05 gms) of that allowed by DIN 20022-2SN and EN 853 Type 2SN. Highly visible lay line branding for easy and permanent identification. No skiving required with Bitelok T200 & T700 Series Crimp Couplings and L Series Field Attachable Couplings.

Working Pressure

Working Pressure

 N/A Dynamic working pressures (in systems with pressure surges or variable loads) are based on 4:1 minimum burst to working pressure safety factor. Static working pressures (in systems with constant loads without pressure spikes) are based on 3:1 minimum burst to working pressure safety factor.

Recommended for

Recommended for

 N/A High pressure hydraulic oil lines in applications where the outside cover of the hose is subjected to abrasion that may cause premature failure of standard hoses. The very high abrasion resistant properties of the cover, combined with the high working pressures and excellent impulse life when tested to EN 853 Type 2SN/SAE 100R2AT test conditions, are designed to increase service life and minimize equipment downtime.
  • 1 For water, emulsions etc.